Wegener UNITY 550, User Manual

Page: 41 / 58

www.wegener.com 800072-01 Rev. A 35
Unity 550 User’s Manual
Local Control
Commands
Local control commands that are always functional at the
Unity 550
Terminal are listed in
Table A.2
. Commands allowed only if local control is enabled by the
COMPEL
network and
are listed in
Table A.1
above.
source:
time:
Time-out value in HH:MM:SS format. Minimum value is 00:00:00 and maximum value is
00:00:30 for Fade and 4660:20:15 for all others.
Timeout.source
is set to time. See
Section 4.3 Acquisition Modes
on page 26 for an explanation of
timeouts.
SNR alarm_level margin_offset
alarm_level : Units in dB with range from 2.0 to 7.0, with one decimal place.
margin_offset:
Units in dB with range from 1.0 (with one decimal place) to difference between 12.0
and alarm_level.
Note: The sum of alarm_level and margin_level cannot exceed 12.0
Sets SNR Alarm Level and Margin Offset accordingly.
TEMP settings time
settings:
See
Section 4.1 Perms/Temps/Searching & Settings
on page 25.
time:
Length of insert in HH:MM:SS format.
Valid range is 00:00:00 to 18:00:00.
Does temporary insert as described in
Table 4.2: Unity 550 Settings Groups
on page 26. Unit sets its
Temp settings to settings.
TEMPCH location time
location: Values from 1 to 48, indicating location in the settings table.
time: Same as for TEMP command.
Unit sets its Temp settings to those retrieved from the settings table according to location. See the
TEMP command.
UNMUTE [source][source]
source:
Same as the MUTE command.
Identical to MUTE command, except that specified services are unmuted.
1 - Fade
2 - Installation
3 - Carrier Search
4 - No COMPEL
5 - (No COMPEL) Header Seek
6 - (No COMPEL) Header Search