Wegener UNITY 550, User Manual

Page: 51 / 58

www.wegener.com 800072-01 Rev. A 45
Unity 550 User’s Manual
Table A.8: Terms Used in Unity 550 MPEG Status Reports
Settings
Status Figure A.7: Sample Unity 550 Settings Status Report
Term Description
Aggregate MPEG If MPEG stream is present, shows Transport stream at data_rate in
Mbps, obtained from active_settings. If MPEG stream is NOT
present, shows Not Available.
Available Programs Program numbers of available programs if MPEG stream is present
Video
Presence NTSC, Not Authorized, or Not Present.
Settings NORMAL if both video.alarm_state and video.cmd_state are
unmuted, Otherwise, any non-muted states will be shown.
Audio Presence Shows 3-character designator for each audio program contained
within the current program, if MPEG stream is present.
Audio Port Only one audio port is possible in the.
Program The audio program that was specified for the audio port. If the unit
automatically picks the audio program, the chosen program will be
shown in ( ).
Routing The value in audio.port.route. Can be STEREO, 1 ON BOTH
(meaning Left to both), 2 ON BOTH (meaning Right to both), or
REVERSE.
Left/Right The status of the port's individual audio component outputs. Can
be -, CMD, ALARM, or ALARM&CMD depending on states of
audio.output.cmd_muted and audio.outputs.alarm_muted.
SETTINGS STATUS
TEMP PERM SEARCH
(00:18:53)
Carrier: 12000.11 12000.11 -
Data Rate: 1.536 10.000 -
FEC Rate: 3//5 3/5 -
Tag Site: 0 2 -
Program: * (EAST) * -
MESSAGE