Wega Polaris 1GR, Use And Maintenance Manual, Instructions For The User

Page: 47 / 228

47
Polaris
ENGLISH
User manual
9
Preparing the coffee
9.1 EMA version
t
Place the coffee cup under the dispensing spout;
t lift up the lever: the delivery will begin, and it
can be stopped using the same switch once the
desired amount of coffee is obtained in the cup.
9.2 EPU version
t
Place the coffee cup under the dispensing spout;
t
press the desired dispensing switch. Dispens-
ing will begin, and it can be stopped using the
same switch once the desired amount of coffee
is obtained in the cup.
Coffee
delivery
Coffee
delivery
9.3 EVD version
Programming coffee dose
Always program the right push-button panel first,
and, if necessary, the others subsequently.
t
Place the coffee cup under the dispensing spout;
t
press the STOP/PROG. button and keep it pres-
sed for 5 seconds: all the push-button panel’s
leds will light up;
t press the dose button to be programmed (e.g.
1 espresso);
t
wait for the dispensing. To confirm the dose,
press the dose button or the
STOP/PROG. but-
ton again ;
t repeat this operation for the other dose buttons;
t Upon the completion of programming, press the
STOP/PROG. button until all the push-button
panel’s leds shut off.
STOP
PROG.
1
Espresso
(Mode)
1 Large
coffee
( + )
Stop/
Continuous/
Programming
2
Espressos
(Enter)
Manual
dispensing
2 Large
coffees
( - )
i
Programming of each dose must be carried out
with ground coffee and not with previously used
grounds.
i
It is possible to program all machine’s push-button
panels simultaneously using only the left push-
button panel. To obtain different doses for the
various groups, perform the programming with
the left push-button panel first, and then with all
the others.
!
Do not remove the filter-holder from the delivery
group during coffee delivery.