Chapter 7
Adjustment and initial operation
40001684 Geset 111
Version: 12.05.14
Page 31 of 56
GB
7. Adjustment and initial operation
Safety instructions
Hazards from actively controlled movements.
RISK OF INJURY FROM CRUSHING!
The movements of the labeling system are motor-driven by an
automatic controller in automatic operation.
- Maintain a distance from moving parts.
Danger of being pulled in by rotating elements.
DANGER OF BEING PULLED IN!
Rotating elements at the labeling system like rewinder, feed
rollers, conveyor belt and *²top conveyor are powered by a motor.
- Do not grip in, at or between the moving parts.
Adjustment and initial operation
The labeling system has to be re-adjusted at initial operation or at a product change . The
adjustments comprise two functions, operation of the controller (refer to manual of the
labeler) and mechanical setup of the assembly groups (explained in the following).
In following adjustment table all required working steps are listed including adjustments of
optional assembly groups which can be skipped if nonexistent. Experienced operators
may use the adjustment tables later on as a checklist.
Requirements
¥
Control about product transport.
¥
One or more sample products.
¥
Labeling system and if so *²turning plate are connected to power
¥
Triggering of the labeling system is possible by product sensor or I/O-interface.
*²
Only if system has the appropriate features.
Instruction
Please put the labeling system Geset 111 into operation as follows.
Step
Procedure
1
Adjust base conveyor (s. from page 32).
2
Adjust side guidance (s. from page 34).
3
Insert label roll in labeler (s. from page 35)
4
Adjust product light barrier (s. from page 35)
5
Adjust peeler plate (s. from page 36)
Summary of Contents for Geset 111
Page 2: ...Blank page ...