Chapter 10
Troubleshooting
40001684 Geset 111
Version: 12.05.14
Page 54 of 56
GB
The label is beveled on the product.
Fig. 10-3: Product with beveled label
Correct the labeling result as follows:
Step
Procedure
1
The inclination of the peeler plate may be adjusted incorrectly. Examine and
correct the inclination of the peeler plate.
2
*² Pusher brush, *² squeegee, *² pusher roller may brake the product too
strongly. Examine and correct this pushing pressure.
*² Only if system has the appropriate features.
The label position changes from product to product.
Fig. 10-4: Product with position displacement of the label
Correct the labeling result as follows:
Step
Procedure
1
The application speed of the label may be too high or too low. Correct the
application speed of the label
2
Examine and correct the sensor for product detection.
3
Examine and correct the distance from peeler bar to product.
4
Examine and correct the stop sensor of the labeler.
5
*² Pusher brush, *² squeegee, *² pusher roller may brake the product too
strongly. Examine and correct this pushing pressure.
6
The start delay time may be too short or too long. Correct the entry of the
start delay time of the labeler in HMI.
*² Only if system has the appropriate features.
Summary of Contents for Geset 111
Page 2: ...Blank page ...