TRC66-86 *** 48
4.3.3 Charging the Sender Accumulator with
the Charger
Important !
The accumulator has a nominal capacity of
600 mAh which provides enough energy for a
continuous sending operation of approximately 12 to
15 hours.
Important !
Whent the red pilot lamp (7/1) lights up and an
acoustic signal is given, the battery must be charged
immediately. The remaining charge is enough for
approximately 15 minutes only, thereafter, the sender
will be automatically turned off.
- Push the switch (7/3) in the "OFF" (0) position.
- Remove the protection cap (7/2).
Caution !
Charging the accumulator is only allowed with the
charger (8/1) delivered with the remote control system.
- To start the charging procedure, put the plug (8/3) into the
socket (7/2) of the sender.
- Connect the charger (8/1) to a socket supplying a constant
voltage of 230 V.
- Charging is finished after approximately 12 to 14 hours.
Important !
The maximum time for charging the accumulator
should not exceed 20 hours.
- To finish the charging procedure, pull off the plug (8/3) and
close the socket with the cap (7/2).
Caution !
If the remote control is not used for an extended
period, the sender should be recharged aproximately
every four weeks in order to prevent a harmful total
discharge.
Figure 7
Figure 8
2
3
1
3
1
Summary of Contents for TRC 66
