Weber mt TRC 66, Operating And Maintenance Instruction Manual

Page: 30 / 60

TRC66-86 *** 30
2.9 Putting the Compactor out of
Operation
Before work breaks and at the end of every day's shift, the
compactor must be parked on a stable base which should be as
horizontal as possible.
If the machine is parked on a slope, use wedge-shaped brake
blocks to prevent any unintentional movement of the compactor.
Danger!
If the compactor causes an obstruction when being parked,
precautionary measures must be taken in order to make
the machine visible. If the machine is parked on traffic
roads, the safety precautions required by the Traffic
Regulations must be additionally observed.
2.9.1 Putting the Compactor out of Operation
Manual Operation
- Release both drive levers (36/1). The compactor is automatically
braked and stopped.
- Push the engine speed adjustment knob (36/2).
Caution !
Never stop the diesel engine when running at full speed,
but let it idle for a short period for cooling down.
- Turn off the engine. To do this, turn the ignition key (36/3)
counterclockwise up to the limit stop, then remove the key.
- Turn the drive levers (37/1).
- Close the anti-vandalism flap (39/1).
2.9.2 Putting the Compactor out of Operation
Remote Control
- Push all levers of the sender (38/1) to neutral position.
- Push the engine speed adjustment knob (36/2) , the
engine's speed decreases to idling speed.
Caution!
Never stop the diesel engine when running at full
speed, but let it idle for a short period for cooling down.
- Turn off the engine. To do this, turn the ignition key (36/3)
counterclockwise up to the limit stop and remove the key.
- Turn the drive levers (37/1).
- Close the anti-vandalim flap (39/1).
Figure 36
Figure 38
Figure 37
Figure 39
1
3
2
1
1
1