Weber mt TRC 66, Operating And Maintenance Instruction Manual

Page: 28 / 60

TRC66-86 *** 28
2.7 Starting the Compactor by Remote Control
Figure 33
Figure 34
5
3
6
7
1
2
4
1
2
1
Danger !
The deadman handle/emergency stop switch
override all other functions of the machine.
If the deadman handle is actuated, the machine will
automatically move forward 0.5 m and will then
stop. The vibration system will be turned off.
Before starting the compactor, ensure that nobody is in the
danger area of the compactor and that all protective devices
are properly in place.
Caution !
Never use starting aid sprays.
- Open the anti-vandalism flap (33/1).
- Turn the drive levers (33/2) to the vertical position.
- Unlock the emergency stop switch (33/3).
- Turn the working speed switch (33/4) to the position.
- Turn the switch (33/5) to the "radio tower" position.
- Turn the igntion key (33/6) to the "1" position.
- Push the engine speed adjustment knob (33/7).
- Push the start switch (34/1), located on the sender of the
radio remote control, to the front, and, at the same time,
pull the R.H. joystick (34/2) (as seen from the direction of
travel) backwards.
- Release both levers as soon as the engine is running.
- Check to ensure that all pilot lamps have gone out, except
the engine lamp (26/2) and the engine speed adjustment
lamp (26/8).
If this does not happen, immediately turnn off the engine
and determine and eliminate the source of the malfunction.
Every time the remote control sender is operated,
the green transmission pilot lamp (34/2) will light up.
If the air filter is restricted, the air filter service
indicator light (26/6) will flash and the engine will be
stopped after 3 seconds in order to avoid damage
to the engine.
- Let the engine idle for a certain time, depending on the
ambient temperature (refer to the chart in figure 27).
Caution!
If the engine fails to start, wait until the engine has
come to a complete standstill, then try to start the
engine again.