Webee Wireless N Router with 3G Modem Support, User Manual, Page: 13 / 91

USER MANUAL OF WEBEE WIRELESS N ROUTER
Version:1.1
Firmware Type 2
P/N: 60291092
13
4. SOFTWARE CONFIGURATION
There are web based management and configuration functions allowing you to have the
job done easily.
The Webee Router is delivered with the following factory default parameters on the
Ethernet LAN interfaces.
Default IP Address
:
192.168.1.254
Default IP subnet mask
:
255.255.255.0
WEB login User Name
:
<blank>
WEB login Password
:
<blank>
4.1. PREPARE YOUR PC TO CONFIGURE THE ROUTER
For OS of Microsoft Windows XP:
1. Click the Start button and select Settings , then click Control Panel . The
Control Panel window will appear.
2. Move mouse and double-click the right button on Network and Dial-up
Connections icon. Move mouse and double-click the Local Area
Connection icon. The Local Area Connection window will appear. Click
Properties button in the Local Area Connection window.
3. Check the installed list of Network Components . If TCP/IP is not installed,
click the Add button to install it; otherwise go to step 6.
4. Select Protocol in the Network Component Type dialog box and click Add
button.
5. Select TCP/IP in Microsoft of Select Network Protocol dialog box then click
OK button to install the TCP/IP protocol, it may need the Microsoft Windows
CD to complete the installation. Close and go back to
Network dialog box
after the TCP/IP installation
.
6. Select TCP/IP and click the properties button on the Network dialog box.
7. Select Specify an IP address and type in values as following example.
9
IP Address:
192.168.1.1
, any IP address within 192.168.1.1 to
192.168.1.253 is good to connect the Wireless LAN Access Point.
9
IP Subnet Mask:
255.255.255.0
8. Click OK to complete the IP parameters setting.
For OS of Microsoft Windows Vista:
1 Click the Start button and select Settings , then click Control Panel . The
Control Panel window will appear.
2 Move mouse and double-click the right button on Network Connections
item. The Network Connections window will appear. Double click Local
Area Connection icon, then User Account Control window will appear.
Right click the Continue button to set properties.
3 In the Local Area Connection Properties window, select Networking tab,
move mouse and click Internet Protocol Version 4 (TCP/IPv4) , then click