19
unbalance value of the rim. Use your hand to pull the wheel. When all the positioning lamps
light inside and outside light, the weight adding position will be indicated.
6.4.7
Rotate the wheel, when the left side positioning lamp all light, at this moment, the highest
position is the inner unbalance position and when the right side positioning lamp all light, at this
moment, the highest position is the outer unbalance position.
6.4.8
Add the corresponding weight at the unbalance point and start test again until the
balance of the tire.
Attention
:
1.
When start the machine, use hand to pull the wheel to help it start rotation, especially to
the relative bigger tire, to prolong the working life of the motor.
2.
Check if there are any mistakes on the dimension. Check if the balance methods meet the
configuration of the rim and select the balancer most easily to balance.
3.
Check if the quick lock nut tight or not.
4.
When the balance ends, remove the tire. Pay attention to handle it with gentle and avoid
knocking the main shaft.
5.
When clipping the weight. Use the hammer to clip the weight on the rim without too much
force. Do not knock the main shaft hardly to avoid damaging the sensor. The position to add
the Weight should be free from the grease and should be dry.
6.5 RESIDUAL UNBALANCE VALUE DISPLAY
The minimum value of the standard weight is 5g so if the weight you use is less than 5 g, the
wheel balancer will not display the value and only
displays the state of ―00‖. When you need to
display the residual unbalance value, you should press
and the display will
immediately display the inside or outside unbalance value of less than 5g. The maximum
residual unbalance value is 4 g.
6.6 BALANCE MODE SELECT
Press the corresponding
key to choose the balance mode. If all the lights not light up, it is the dynamic mode
.
DYNAMIC
—clip the weight on both sides of rim
(
dynamic balance test once start
)
STATIC
— Stick the weight in centre
MOT
—optional for balancing the motorcycle
When balancing motorcycle wheels, you require the (optional) motorcycle adaptor accessory
MJ-II. With the assistance of the extension scale to measure Di, Br and Di. Input the measure
Summary of Contents for W-957-40
Page 1: ...1 ...
Page 38: ...38 APPENDIX 1 POWER DOARD LAYOUT ...
Page 39: ...39 APPENDIX 2 CIRCUIT SCHEME ...
Page 40: ...40 ...