10
(10% when start)
-Operators must:
• Install the plug;
• install 30ma circuit breaker;
• install power cable fuse;
• provide with effective workshop electrical connect to ground;
- prevent the authorized operation and pull out the plug to prolong the working life when not
use the machine.
- If the machine directly connected to the power source through the power board not the plug,
we should use the qualified staffs to operate.
Perfect ground is necessary for the correct operation. Do not connect the machine with air pipe,
water pipe, telephone line and the other unsuitable objects
3.
TECHNICAL FEATURES
3.1 FEATURES
：
－
adopts quality computer with the feature of high intelligence and high stable
－
mechanical main shaft adopts high precision bearing driven, wear-resistant, low noise
－
press stop key to realize the emergency stop
－
full automatic dynamic/static balance check
－
balance 3 ALU rim and 1 motorcycle tire
－
self-calibration and full automatic trouble diagnosis
3.2MAIN TECHNICAL SPECIFICATION
－
rated voltage 220V/110V
（
selectable
）50/60HZ、380V/50HZ/1P
－
power 250W
－
speed 7S
（
if the weight of the wheel is about 20Kg
）
－
accuracy ±1g
－
noise
≤69dB
－
rim diameter
10″
～
24″
－
maximum wheel weight 65kg
－
rim width 1.5
～
20″
－
max wheel diameter 44inch
Special instruction：
For the outreach of the main shaft is limited,
so there issome limit to the distance from
flange disk to the outside edge of the tire
should less than 170mm as shown in the figure.
On this condition, you can operate correctly.
Distance
from
flange disk to the
outside edge of the
tire
Summary of Contents for W-957-40
Page 1: ...1 ...
Page 38: ...38 APPENDIX 1 POWER DOARD LAYOUT ...
Page 39: ...39 APPENDIX 2 CIRCUIT SCHEME ...
Page 40: ...40 ...
