18
input the DI value into the display. At this moment, the display will display
[DIS]
:
[XXX]
,
And the
default system is mm.
6.4.2 Input Br (RIM Breadth) Value
Use the Br measurement caliper to measure the Br of the rim, press the key
to
input the Br value into the display. At this moment, the display will display
[Br. ]
:
[XXX]
. and the
default system is inch.
6.4.3 Input the DiA(Diameter)Tire Diameter Value
After confirming the rim diameter, press the key
to input the rim diameter into
the display. At this moment, the display will display
[Dia ]
:
[XXX]
. and the default system is
mm.
6.4.4 UNIT CONVERSION
:
①
The unit conversion of the Br of the rim from inch to mm:
Normally, the display of Br should be in inch. When you need the unit of the display to be mm,
you can use the
key to realize the unit conversion from inch to mm.
②
The unit conversion of the DIA of the rim from inch to mm:
Normally, the display of D should be in inch. When you need the unit of the display to be mm,
you can use the key
to realize the unit conversion from inch to mm.
After unit conversion, the unit of the display values of rim Br and D value, but when you switch
off and then on the wheel balancer, the unit will be still inch.
③
The unit conversion from gram to ounce
:
Normally, the unit of the unbalance value is gram (g). If you want to make the ounce (Oz) to be
the unit, you can execute the g/Oz conversion. The unit of the displayed unbalance value is
gram
(
g
)
. The way to realize the unit conversion from gram to ounce is to press
6.4.5
When press the start key
,
the wheel balancer starts to run. A few seconds later, the
machine automatically stops. The machine can also start by lowering down the protective hood
which can be set by the program.
6.4.6 DISPLAY UNBALANCE VALUE
When the spin ends, the display will display the inner
and outer
Summary of Contents for W-957-40
Page 1: ...1 ...
Page 38: ...38 APPENDIX 1 POWER DOARD LAYOUT ...
Page 39: ...39 APPENDIX 2 CIRCUIT SCHEME ...
Page 40: ...40 ...