Tools Needed:
You can reach us Toll Free at
1-888-827-3667
for Consumer Assistance or online at
www.wayne-dalton.com
Please Do Not Return This Product To The Store.
Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
39
FAILURE TO DISCONNECT ELECTRICAL
POWER AT FUSE/BREAKER BOX BEFORE
PROCEEDING COULD RESULT IN
ELECTRICAL SHOCK.
Important!
Disconnect electrical power
at fuse/breaker box.
If required by local codes, the Opener can
be permanently wired. Services of a
licensed electrician should be obtained to
permanently wire the unit.
Unplug the Motor Power Cable.
Using a Phillips Head Screwdriver, remove
the two screws from the right hand
Cover. Remove the right hand Cover from
the Opener to expose electronics and
wiring.
Wiring the Power Connection:
a.
Remove the strain relief fitting,
including its wires and discard.
b.
Attach conduit with conduit nut, insert
field wires and cut wires, allowing 6” of
additional wire length. Strip off 3/4” of
insulation from each wire and form a
loop at the ends of the wires as shown
in the illustration at lower right.
Positioning Wire:
c.
Position wiring as shown in the
illustration, keeping them to the left
side of the Circuit Board.
d.
Attach wires to Screw Terminals on the
Circuit Board with black wire to BLK
Terminal, white wire to WHITE Terminal
and the green with yellow stripe wire
to the frame using the provided #8
screw.
Replace the right hand Cover over the
Opener’s electronics and secure with the
two Screws. Plug Motor Power Cable into
Opener.
Opener Permanent Wiring
Remove Cover
Wiring Power Connection
Positioning Wire
a
b
c
d
Motor Power Cable
(2) Screws
Conduit
Conduit Nut
Loop
Green
(Ground)
Conduit
Nut
#8 Screw
Black
(Live)
White
(Neutral)
Phillips Head
Screwdriver
Flat Tip Screwdriver
Wire Cutters/ Stripper
Pliers
Strain Relief Fitting
25
WARNING
