Tools Needed:
INST
ALLA
TION
You can reach us Toll Free at
1-888-827-3667
for Consumer Assistance or online at
www.wayne-dalton.com
Please Do Not Return This Product To The Store
Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
Organizing Safety Sensor
Sender and Receiver Wires
IMPORTANT!
Keep Safety Sensor Wires
away from moving parts.
Keep the Safety Sensor Wires straight and
organized by wrapping them around the
backside of the Opener and securing
them using the Sensor Wire Clip
(adhesive backed). (Ensure the surface
the wire clip is attached to is clean and
oil free).
Position Right Hand Gear Assembly so it
is 1/8” from the Opener. Right Hand Gear
Assembly Square Head Bolt should be
hand tightened, then with a wrench
tighten 1 to 1 - 1/4 turns to secure Gear
Assembly.
20
Tools Needed:
3/8” Wrench
Right Hand
Drive Gear
Square
Head Bolt
Right Hand
Gear Assembly
1/8”
Sensor
Wire Clip
10
19
Connecting Safety Sensor
Wires to Opener
Expose the Terminal Block by sliding the
right hand Gear Assembly to the right.
Using a pair of Needle Nose Pliers, gently
pull terminal block from right hand side of
opener. Separate wire ends and strip
about 1/2” of the insulation off each of
the wire ends.
Using the Flat Tip Screwdriver to loosen
the screw above Hole #1 of the Terminal
Block. Insert both sender and receiver
solid white wires into Hole #1. Tighten
the screw above Hole #1 till both sender
and receiver solid white wires are
secured tightly. Insert both sender and
receiver wires (white with black stripe)
into Hole #2 by the same process. After
wires are secured in Terminal Block, snap
Terminal Block back in right hand side of
opener.
Wire cutters
Flat Tip
Screwdriver
Needle Nose
Pliers
Hole #2
Hole #1
Flat Tip Screwdriver
Terminal Block
Needle Nose
Pliers
White with
Black Stripe
Solid White
Wires
