Tools Needed:
You can reach us Toll Free at
1-888-827-3667
for Consumer Assistance or online at
www.wayne-dalton.com
Please Do Not Return This Product To The Store.
Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
13
Mark a location on the right jamb, 6 feet
above the floor to mount the Disconnect
Handle Bracket. Align top of the Bracket
with the mark. Drill pilot holes using 1/8”
drill bit. Fasten Bracket to the jamb with
(2) 1/4 x 1-1/2” Lag Screws.
Mounting Disconnect
Handle Bracket
Tools Needed:
Pencil
Tape measure
Drill with 1/8” bit
7/16” Socket
Driver
Start the #6-20 x 1/2” Screw into the
Handle. Thread the Disconnect Cable
through the top of the Handle Bracket and
then the Handle. Locate the Handle in upper
position of Handle Bracket.
Remove all cable slack between the Opener
and the top of the Handle Bracket. Pull the
Disconnect Cable only enough to remove the
Cable’s slack (
pulling the Cable more
could cause Opener to disconnect from
the Torsion Tube
).
NOTE:
If Motor disconnects from Torsion
Tube refer back to step 8.
Tighten #6-20 x 1/2” screw into the handle
until snug, and then tighten screw an
additional 1 to 1-1/2 turns to secure cable
to handle. Trim off excess cable from bottom
of the handle.
Apply Emergency Disconnect Label next
to the Disconnect Handle Bracket. Use
mechanical fasteners if adhesive will
not adhere.
Note:
Pulling the Disconnect Handle down
and hooking it to the bottom of the
Disconnect Handle Bracket will place the
door in manual operated position. When
releasing the Disconnect Handle from the
manual operated position to the motor
operated position, the Disconnect Cable will
be slacked. This is normal. When the Opener
is activated the slack will be taken up.
Attaching Disconnect Handle
14
Tools Needed:
Phillips head
screwdriver
Wire cutters
Opener
Disconnect Handle
Bracket
Right
Jamb
6’
#6-20 x 1/2”
Screw
Disconnect
Handle
Bracket
Disconnect
Cable
Handle
Motor operated position
Manual operated position
Upper Position
7
Emergency Disconnect Label
FEET
FROM
FLOOR
