Pico
™
on-the-go car seat
INSTRUCTION MANUAL
TO PROVIDE A SECURE INSTALLATION OF THE CAR SEAT
Read the vehicle owner’s manual regarding securing a car seat and vehicle
seat belt use with car seat.
Follow all instructions in your vehicle owner’s manual, this manual and the labels
on car seat. If car seat does not stay tightly secured after following instructions
in this manual and in
your vehicle owner’s manual:
Move car seat to another seating location and try again, or install with LATCH.
Contact vehicle dealer for assistance and seat belt modification parts, when available.
See the “Assistance” section of this manual (pg. 2).
VEHICLE BELTS THAT MAY BE USED WITH THIS CAR SEAT
Any of the following belt types may be used to install this car seat as long as a secure
installation can be achieved, the vehicle belt stays tightly adjusted and the seating position
and vehicle belts are approved for installation of a car seat in the vehicle owner’s manual.
See “Vehicle Seat Belt Installation” section for installation instructions (pg. 29).
Most lap & shoulder belts with free sliding latch plate
have switchable retractors.
Gently pull the shoulder belt out until it stops.
Gently let the shoulder belt retract about 6 in. (15 mm).
Pull back out on the shoulder belt.
If the shoulder belt is locked and does not pull out, then
you have a switchable or automatic retractor which can
be used with this car seat.
Retractor MUST always be switched to locking mode
when tightening vehicle belt to secure Pico.
COMBINATION LAP & SHOULDER BELT WITH FREE SLIDING LATCH PLATE
WAYB strongly recommends installing the Pico with
LATCH
whenever
it is possible to correctly install with
LATCH.
The
LATCH
system generally
allows for the easiest installation.
Design and operation of vehicle seat belt systems vary from vehicle to vehicle and
from seating location to seating location in the same vehicle. Not all vehicle seat belts
can be used with a child restraint.
Read this section and check your vehicle owner’s manual for information about what type
of vehicle belts your vehicle has and if they can or cannot be safely used with this car seat.
12
13
NOTE:
If the belt pulls out, the retractor is an emergency locking
retractor which can be used to install car seat but MUST
be used with a locking clip. Please contact WAYB
at
1-888-924-WAYB
(9292) or email
to request a free locking clip.
Install car seat and tighten vehicle seat belt.
Hold vehicle seat belts together at latch plate and unbuckle.
Slide locking clip on seat belts approximately
1 in. (2.5 cm) away from latch plate.
Re-buckle seat belt.
Retest for secure installation and verify that lap belt stays tight.
NOTE:
Call
1-888-924-WAYB
(9292) or email
to request a free locking clip.
Locking
Clip
TO USE LOCKING CLIP
