![background image](http://html1.mh-extra.com/html/wayb/pico/pico_instruction-manual_3899279016.webp)
Pico
™
on-the-go car seat
INSTRUCTION MANUAL
29
28
VEHICLE SEAT BELT INSTALLATION
TETHER STORAGE
Store tether in storage pocket on back of car seat.
STORAGE OF LOWER ANCHOR BELT AND CONNECTORS
When not using the LATCH System, store the lower
anchor belt and push-on connectors on the LATCH
storage bars on both sides of car seat.
Pull the red loop on the push-on connector storage
bar and push the connector onto the bar.
WARNING
• Tether MUST always be used if vehicle tether anchor is available.
• Not all vehicle seat belts can be used with this car seat.
Read vehicle owner’s manual and the “Vehicle Seat Belt
System Overview” section in this manual (pg. 11).
• Vehicle seat belt MUST stay tightly adjusted around car seat
at all times. If vehicle seat belt does not stay tight, read the
vehicle owner’s manual and the “Vehicle Seat Belt System
Overview” section in this manual (pg. 11).
Refer to vehicle owner’s manual to identify the seating
locations which can be used with a car seat. Check for
specific instructions for car seat use.
After selecting a seating location, if vehicle seat back is
adjustable, adjust seat back into most upright position
or the position specified in the vehicle owner’s manual.
Set Pico up for use by unfolding and locking into use
position, see the “Setting Up Pico” section for assistance (pg. 17).
Check that fold lock is securely engaged.
Remove tether from storage compartment
on back of car seat and place in seating area
of car seat.
2
1
1
2
Check out support videos at
www.wayb.com/pages/support.
Point your smartphone’s camera
directly at the QR Code to activate.