![background image](http://html1.mh-extra.com/html/wayb/pico/pico_instruction-manual_3899279017.webp)
Pico
™
on-the-go car seat
INSTRUCTION MANUAL
31
30
If your vehicle belt is equipped with a
switchable retractor, switch it to locking mode.
NOTE:
See the “Vehicle Seat Belt System Overview”
section of this manual for assistance (pg. 11)
Route vehicle belt between the backrest and car seat
frame. Place the vehicle lap belt or lap portion of a lap
and shoulder belt into both vehicle belt guides on the
front of the car seat frame, behind the backrest.
Place car seat forward-facing in the vehicle seat location
selected, centered between the vehicle belt anchors.
Lap belt MUST be through both belt guides.
Tighten vehicle seat belt to secure the car seat.
FOR VEHICLE LAP BELT ONLY
Place your hand in center of car seat bottom and use leverage to
compress the car seat into the vehicle cushion while tightening the
vehicle lap belt.
NOTE:
Rocking the car seat from side to side while tightening may
assist in getting the lap belt tightly adjusted.
Locate the tether anchor for the seating location being used
if available. If no tether anchor is available, skip next step.
NOTE:
Check vehicle owner’s manual for tether anchor
locations and proper routing of tether strap in relation
to vehicle headrest. DO NOT use cargo tie downs or
other attachment points not intended for use with
car seats. Look for the tether anchor symbol:
Attach tether hook to vehicle tether anchor and pull strap
to remove slack from tether. Check that the tether strap is not
twisted. Final tightening will occur in a later step.
NOTE:
To lengthen the tether strap, push the tether adjuster
button and pull the tether strap through the adjuster.
2
1
1
2
Tether MUST always be used when available.
Shoulder belt MUST NOT be through either belt guide.