WaveRider NCL1170, User Manual

Page: 76 / 97

62 APCD–NC006–A
ip tr aceroute
destination(aaa.bbb.ccc.ddd)
Displays the route that the packets take to a remote
destination.
destination(aaa.bbb.ccc.ddd)
is
the IP address of the remote destination. The maximum
is 30 hops. An asterisk (*) represents each unsuccessful
try. For example, 1 * * *. Press any key to stop the
ip
traceroute
output.
m ode
Displays the forwarding mode: Bridging or IP Routing.
m ode bri dging| rou ting
Changes the forwarding mode.
bridging
: connects two networks on the same subnet
(they have the same subnet address).
routing
: connects two networks on different subnets.
ra dio
Displays the radio configuration information.
ra dio ch annel
Displays the radio channel.
ra dio ch annel (1–14)
Changes the radio channel.
ra dio d isable| en able
Disables or enables the NCL1170 radio transmission
capabilities. The NCL1170 is factory-configured as
disabled to prevent accidental damage should it be
powered up without an antenna or load connected.
ra dio m asterID
Displays the Master Unit ID to which the NCL1170
belongs. Available only if the NCL1170 radio type is
Station.
radio m asterID (1–16383)
Changes the Master Unit ID to which the NCL1170
belongs. Available only if the NCL1170 radio type is
Station.
ra dio per
[
s
ingle|
c
ontinuous|
r
eset]
Displays or resets the cumulative radio packet error rate
statistics to the screen. This command is available
during tests and normal operation.
•
single
displays the current statistics.
•
continuous
displays the statistics every one
second.
•
reset
resets the calculations.
ra dio r eset
Forces the NCL1170 radio to reset. If you reset the
NCL1170 radio instead of shutting down, the statistics
will not be lost.
ra dio rssi
When serially connected to the NCL1170, displays
changes in the average and peak receive signal
strength every half second.
ra dio rssi threshold
Changes the threshold (floor) value used to calculate
the average receive signal strength.
ra dio rx test sta rt| sto p
Starts and stops the Radio Continuous Receive Test.
When you start this test, the Radio PER display is also
automatically started. Available only at the Station
NCL1170. Use this test to deploy a new Station
NCL1170 in an existing network.
Command Syntax Description