WaveRider NCL1170, User Manual

Page: 25 / 97

APCD–NC006–A 11
3
Installing the NCL1170
This section describes the steps required to connect and initialize the NCL1170 hardware prior
to configuring the device as a bridge or router.
WARNING!
Antennas and associated transmission cable must be installed
by qualified personnel. Failure to terminate the antenna port
correctly can permanently damage the NCL1170. WaveRider
assumes no liability for failure to adhere to this recommendation
or to recognized general safety precautions.
WARNING!
Connect only shielded twisted pair (STP) Ethernet cable to the
10Base Tx Ethernet (RJ-45) port on the NCL1170. It is the
responsibility of the installer to supply and use the correct type
of Ethernet cable.
WARNING!
The AC adapter shipped with your NCL1170 is the only approved
power supply for this device. Attempting to power the NCL1170
from any other source—even if it meets or exceeds our product
specifications—will void your warranty unless you obtain prior
approval in writing from WaveRider Customer Support.