Watts Vision BT-CT02-RF, Manual

Page: 4 / 52

4
6-
WIFI status .
WIFI settings reading button (refreshment).
The Internet Access password allows to link your central unit to
your Internet account (See below) for a remote control of your
system through the Internet or Smart Phone.
n.b.: At first use or software update, wait for some time until the
green State icon is active.
7-
Holidays menu.
- To set the departure/return dates and hours.
- Use < or > to select year/month/day, hour & minute.
- Set and valid the operating mode of the devices in holiday
mode. (Same menu than general menu).
8-
Installation menu (long press 3-4 s)
A. House creation.
B. Radio pairing.
C. Delete a device:
Select device type and then the device.
D. Delete all devices:
All devices installed in the system will be deleted (rooms
will be maintained).
E. Identify a device
To identify a device of the installation
a- To put the menu in reception mode.
b- To access to the device parameters.
Process :
-
Press on ‘a’ to make the Central listening
- Press on the device receiver and wait a few seconds until
radio communication frame is transmitted.
Note: ID-number is displayed on the screen, please repeat to
be sure to have the same ID.
- Long press on to change device name, power.
F. Antifreeze setpoint:
You can set the antifreeze setpoint as reference for the whole
installation.
G. Heating settings:
You can fix setpoint limitations (min/max) per zone and the
offset assigned to devices working in floor sensor regulation.
H. WIFI settings:
To set the WIFI configurations (SSID/Protected Access Key
Type/ Password). You can do it manually or scan the active
networks.
n.b.: The connection to Internet is recommended with Certified
WiFi routers (http://www.wi-fi.org/certification).
n.b.: Automatic pairing time to WiFi router
with WEP key: 3-4 min, with WPA2 key: 1 min.
I. General factory default:
To reset the system with the factory values, but the software
version will remain the same.
J. Update Firmware:
To update the software, with the SD-card. The system is
qualified to work with SD-cards less than or equal to 16GB.
Select

to proceed.
The SW and the procedure to update the central unit is
available on: http://www.wattselectronics.com/
A
B
C
D
E
F
G
H
I
J