15
95 Parameters for factory adjustment,
96
Do Not change .
Fault contact
control
97
xxx0 : Fault contact is not energized during auto restart operation
xxx1 : Fault contact is energized during auto restart operation
xx0x : Fault contact is not energized during momentary power loss det.
xx1x : Fault contact is energized during momentary power loss
detection
x0xx : Fault contact isn‘t energized during external Emergency Stop
x1xx : Fault contact is energized during external Emergency Stop
0xxx : Fault contact is not energized during external base block
1xxx : Fault contact is energized during external base block
0000
98
xxx0 : Fault contact is not energized after overtorque is detected
xxx1 : Fault contact is energized after overtorque is detected
xx0x : Fault contact is not energized after electronic thermal motor
protection is acting
xx1x : Fault contact is energized after electronic thermal motor
protection is acting
x0xx : Fault contact is normal open (N/O)
x1xx : Fault contact is normal close (N/C)
0xxx : Fault contact is not energized after electronic thermal inverter
protection is acting
1xxx : Fault contact is energized after electronic thermal inverter
protection is acting
0000
Communication 99
Reserved
parameter
100 Communication identified no.
1
1-32
*3
*2
control
101 Baud rate of communication
1
0 : 4800 bps
1 : 9600 bps
2 : 19200 bps
3 : 38400 bps
*3 *2
102 xxx0 : 1 stop bit
xxx1 : 2 stop bits
xx0x : Even parity
xx1x : Odd parity
x0xx : With parity
x1xx : Without parity
0xxx : 8 bits data
1xxx : 7 bits data
*3 *2
