Watkiss P2T, Unpacking And Installation Instructions

Page: 33 / 84

P2T 2-Knife Trimmer Page 3-9 CHAPTER 3 - Prepare the BLM
Issue 1b, June 2018
Fit the Installation Hardware to the BLM
5 Connect the red and violet
cable from the cover
mounting bracket to PL5
of the 900-227 stacker
interface PCB.
• Use a small cable tie, item  Figure
3:7. to fasten the cable to the stacker
PCB bracket.
6 Connect the earth wire
from the cover mounting
bracket to the BLM.
Step Action Information
7 Fit the pivot location
bracket and pivot clamp
bracket to the BLM. Item

and item

, Figure 3:7.
• Remove the M5 screws and washers to
separate items
 and 
• Fit the pivot location bracket  to the
front of the lower chassis rail of the BLM,
then slide to the right.
See
Figure 3:10. and Figure 3:12.
• Fit the pivot clamp bracket  behind the
lower chassis rail of the BLM. Make sure
the screw holes in the pivot location
bracket align with the threaded holes in
the pivot clamp bracket.
• Use the 2 x M5 screws and washers to
connect items

and

.
8 Fit the pivot bracket to the
P2T. Item

, Figure 3:7.
See Figure 3:14.
• Use the screws supplied to fasten the
pivot bracket to the underside of the P2T.
Step Action Information