Watkiss P2T, Unpacking And Installation Instructions

Page: 66 / 84

P2T 2-Knife Trimmer Page B-10 APPENDIX B - Uninstall the P2T
Issue 1b, June 2018
Load the P2T onto the Pallet
Transit bracket
Brake
Castor
Foam rubber packing
Figure B:16. Castor
Back panel
Side screw
Trim bin
Figure B:17. Trim bin
Step Action Information
1 Important:
When you push the P2T up the
ramps, make sure the infeed faces
to the left.
See Figure B:13.
2 Push the P2T up the ramps and
onto the pallet. See Figure B:13.
When the P2T is far enough onto
the pallet, you will feel the castors
engage with a recess in the metal
channel.
3 Rotate the bracket assemblies
inward. • Rotate the bracket assemblies
inward.
See ‘A’ in
Figure B:14.
• Fit the retaining bolts to the
ramp end of the bracket assem-
blies.
See ‘B’ in
Figure B:14.
4 Align the threaded holes in the P2T
with the holes in the transit
brackets. See Figure B:15.
5 Loosely fit the shipping bolts.
6 Lower the lift bracket. • Turn the screw to the left until
the lift bracket is at the lowest
point.