Watkiss Automation PowerSquare 200, User Manual

Page: 50 / 80

5 - Error Conditions, Problems and Solutions - Stitch Head Problems
46
Watkiss PowerSquare™200 User Manual
Stitch Head Problems
Clear a Stitch-wire Jam
Before You Begin
Lift the PowerSquare main deck. See “Lift the PowerSquare Main Deck” on
page 25.
Problem Cause Solution
The stitch head does
not operate The
STITCH
function is
not selected.
Make sure
STITCH
is set to
1
or more.
See “STITCHES” on page 15.
The stitch-wire is fin-
ished. Load a new spool of stitch-
wire. See “Install New Stitch-
wire” on page 63.
The stitch-wire is
jammed. Clear the jammed stitch-wire.
See “Clear a Stitch-wire Jam”
on page 46.
The stitches are bro-
ken There is stitch-wire
jammed in the stitch
head. Inspect and remove the
jammed stitch-wire. See
“Clear a Stitch-wire Jam” on
page 46.
The stitch-wire is
jammed on the spool The stitch-wire spool is
not installed correctly. Check and correct.
See “Fit a New Stitch-wire
Spool” on page 65..