Watkiss Automation PowerSquare 200, User Manual

Page: 69 / 80

6 - Maintenance - Install New Stitch-wire
Watkiss PowerSquare™200 User Manual
65
Fit a New Stitch-wire Spool
Install the Stitch-wire into the Stitch Head
Step Action Information
1 Open the stitch-wire cabinet.
2 Remove the stitch-wire cap and
finished stitch-wire spool.
3 Fit a new stitch-wire spool.
4 Fit the stitch-wire cap.
5 Loosen the end of the stitch-wire
from the edge of the stitch-wire
spool.
6 Use wire-cutters to remove the
damaged end of the stitch-wire. Remove enough stitch-wire to
leave the end of the stitch-wire
clean and straight.
7 Feed the stitch-wire through the
stitch-wire guide.
8 Install the stitch-wire. See “Install the Stitch-wire into the
Stitch Head” on page 65.
Step Action Information
1 Pull the stitch-wire from the end of
the stitch-wire guide.
2 Make sure the stitch-wire runs
behind the gas-strut.