December 5, 2017, 715004753 Rev. B
Page 30
Figure 2–2:
Location of power input on the detector’s rear panel
2.
Connect the male end of the power cord to a suitable wall outlet.
3.
Press the On/Off switch, on the front door, to power-on the detector.
Result:
The detector runs a series of startup diagnostic tests while the lamp LED blinks
green. The lamp LED shows steady green when the lamp is ignited.
2.6
Connecting signal cables
See also:
Waters Ethernet Instrument Getting Started Guide
.
The following figure shows the rear panel location of the connectors used to operate the 2998 PDA
detector with external devices.
Figure 2–3:
Location of connectors on 2998 PDA detector rear panel
The cables that you must connect depend on the connections available on the other instruments
included in the system.
Power input
Signal cable connector
inputs and outputs
RS-232 cable
connector (for
service only)
Ethernet cable
connector
Summary of Contents for 2998
