T-365
Page 35 of 75
Disassembly - Disassemble Cap (Continued)
Hydraulic Pump on Front and End Yoke on Rear
Hydraulic Pump
Adapter
Retaining Ring
Bearing
Driven Sprocket
Driven Shaft
Bearing
Oil Seal
Locknut
Rear Cap Flange
Four (4) 3/8-16 x 1 in.
Screws and Lockwashers
Front
Rear
Front Cap Flange
Oil Seal Housing
O-ring
Wave Spring
Key
Cap
1.
Remove the end yoke and locknut. Discard locknut.
2.
Remove the screws that fasten the hydraulic adapter and oil seal
housing to the cap. Remove adapter and housing. Discard oil seals.
3.
Remove retaining ring from shaft.
4.
Under a press, support the assembly on the rear face side of the
cap and apply a press load to the end of the driven shaft to press
the shaft out of the ball bearing, spacer and sprocket.
5.
Remove the ball bearing, spacer and sprocket from cap.
6.
Remove the rear ball bearing from the shaft.
End Yoke
O-ring
Spacer
Four (4) 3/8-16 x 1 in.
Screws and Lockwashers
Oil Seal