![background image](http://html1.mh-extra.com/html/waterlogic/wl15/wl15_installation-manual_3642906002.webp)
WL15
Manual
Page 34 – Revision: 4-15-22
Materials Needed:
Personal Protective Equipment. Rubber or Nitrile Safety Gloves and Protective Eyewear
Phillips Screwdriver
Temperature Gauge
Water Pitcher or Container to collect water from the faucet
5-gallon container or drain basin
Sanitizer - Household Bleach (5.25% Sodium Hypochlorite) or Citric Acid Based Cleaner
1/4” Plastic Tubing and assorted 1/4” quick connect fittings
Sanitizing Cartridge
Food Coloring (optional)
1.
Unpack the
Waterlogic WL15 Water Dispenser
and check exterior for damage.
2.
Identify the ports on the back of the machine. All ports are
clearly labeled. The top port of the drainage is not used, only
the lower port is connected and will drain the hot tank. Make
sure the power switches on the back are turned OFF
(
O=OFF
).
3.
Remove the top cover by removing the two screws holding the lid in place (
2
)
and sliding back and lifting from the unit. Remove the other screws shown to
release the side panel (
4
), then slide it back and pull away from the unit