WL15
Manual
Page 37 – Revision: 4-15-22
WL15 DRAINING PROCEDURES
CAUTION!
STORE UNIT EMPTY. ALWAYS SANITIZE BEFORE REUSE.
The unit must be completely drained and sealed before storing to avoid stagnation and
reduce microbial growth
DANGER!
HOT WATER.
The Waterlogic WL15 Water Dispenser produces Hot Water up to 87°C (188°F). Water
above 52°C (125°F) can cause severe burns or scalding. Hot water should be dispensed
carefully into insulated container to avoid injury.
1.
To drain the tanks of the Waterlogic WL15 Water Dispenser, first start
with draining the Hot Tank. Shut off the Hot Switch on the back of the
machine and dispense Hot water until it is cool to the touch.
2.
Now, shut off the water supply.
3.
Locate the drain port on the back of the machine. Use a screwdriver to slightly
loosen the screw at the center of the drain port, which will allow the lower cap to be
turned 180 degrees and removed.
Have a bucket or pitcher ready to catch the
water as it drains out of the port.
4.
Once the water has completely drained from the Hot tank, replace the drain port
cap and secure by tightening the screw down over the cap lip.
5.
Next, drain the sparkling water from the system. Place a pitcher or the like in the
dispensing area to catch the water as it comes out. With the gas connected and the
Soda switch turned on, begin dispensing Sparkling water until only gas is coming out
of the spout. Promptly turn off the Soda switch and shut the gas off at the bottle.
6.
Again, with a pitcher in the dispense area, connect the gas line to the Water Supply
port and turn the bottle on. Dispense Cold water from the system until only gas
comes out of the spout (
it will only be a few ounces of water).
Shut the gas off and
disconnect the line. Dispense Cold water one last time to break any pressure buildup
in the line.