WaterLogic NIAGARA IB, Manual

Page: 30 / 48

30
5561304
6.3 CONNECTION TO THE CO2 CYLINDER (AC WG models)
NI1404-120
CO
2
5
4
3
6
7
8
9
1
2
CO
2
cylinder charging range Lt
CO
2
flaskens autonomi
CO
2
-tuben räcker
Varighet CO
2
–flaske usg
Автономность баллона CO
2
CO
2
cylinder capacity
flaskens kapacitet
Tubvolym CO
2
CO
2
–flaskens kapasitet
Вместимость баллона CO
2
4 Kg (8,8 Ibs)
700
184,1
10 Kg (22 Ibs)
1600
420,8
For the production of carbonated water, you must provide a CO
2
cylinder
for alimentary use.
To connect the gas cylinder to the machine:
• Connect the pressure reducer 3 to the cylinder 1 , making sure the
gasket 9 is in the correct position.
• Tighten nut 8 and check that the pipe 5 (outlet) is well connected.
• Floor-based SL models:
Extract the front panel.
Place the cylinder and reducer within the appliance, in the predis-
posed housing.
• The bottle has to be fixed with the special included pieces.
• TOP and IN models
the cylinder is secured outside the machine.
1) CO2 cylinder
2) CO2 cylinder tap
3) CO2 pressure regulator
4) CO2 pressure adjusting screw
5) CO2 outlet pipe
6) Cylinder internal pressure gauge
(shows whether there is any gas inside the cylinder)
7) Outlet CO2 pressure gauge; the value should be of 3÷4 bars.
This value is set at the factory. If necessary, turn screw 4.
8) Tightening nut
9) Seal
19
EN
Due to the pressure that may be present when carrying out
maintenance operations upon the CO2 circuit, the operator is
required to make use of personal protective equipment (PPE),
such as protective gloves and a protective face mask
The cylinder must not be exposed to direct sunlight and
must not be stored in any environment where the room tem-
perature may exceed 50° C.
Reserved to qualified operators - Forbeholdt faglærte operatører - Reserverad för kvalificerade operatörer - Reservert for kvalifiserte operatører - Только для
квалифицированных специалистов