WaterLogic NIAGARA IB, Manual

Page: 22 / 48

22
5561304
NI1404-110
NI1404-100
NI1404-090 piano
T
A
R
P
K
• This water dispenser can be equipped with a WATER BLOCK anti-flooding
device (optional) to prevent any accidental water leaks (fig.9).
Once the WATER BLOCK device has intervened, fitting K should be
disassembled and button P pressed to reset the device.
• If instead of being connected directly to the aqueduct the machine is
connected to an autoclave pump, then it is necessary to install above the
water supply an ANTISHOCK device to prevent “water hammers” (fig.9.1).
5.2 WATER CONNECTION TO THE MAINS
Before water connection, check that the network pressure is between 2 and
3 bar and flow more than 3.5 l/min .
• For the connection to the water main use only the provided “hose set”; it
must be managed by an appropriate tool; it can’t be removed (fig.11,13,14).
Warning!
In the event that the installation kit (and the group of connections) is dam-
aged, it must be replaced by the manufacturer, an authorized technical
assistance service or by another a qualified individual in order to avoid
any risks.
• If the mains pressure is below 2 bar or the flow rate is less than 3,5 l/
min , fit a device capable of increasing the mains pressure (such as an
autoclave or similar).
8
9.1
10
9
EN
During connection of the appliance to the mains water sup-
ply, all pre-existing tubes, gaskets and joints placed betwe-
en the appliance and the water mains connection must be
replaced with new material to avoid contamination.
N.B.: the pressure is especially important for those water coolers
fitted with a carbonation device.
Attention! All models 62,120,180 are equipped with a water pres-
sure reducer calibrated at 3 bar, installed on the machine on
ground models and supplied separately with other models.
Reserved to qualified operators - Forbeholdt faglærte operatører - Reserverad för kvalificerade operatörer - Reservert for kvalifiserte operatører - Только для
квалифицированных специалистов