System Start-Up
Key Pad Configuration
SETTINGS
This
function
is
to
enter
the
basic
set
up
infor
‐
mation
required
at
the
time
of
installation.
MANUAL
REGEN
This
function
is
to
initiate
an
immediate
or
delayed
manual
regeneration.
DOWN
/
UP
Increase
or
decrease
the
value
of
the
settings
while
in
the
programming
mode.
SETTINGS
MANUAL
REGEN
UP
DOWN
1. Plug the power transformer into an ap-
proved power source. Connect the power
cord to the valve.
2. When power is supplied to the control, the
screen will display “INITIALIZING WAIT
PLEASE” while it finds the service position.
3. Manually step the valve past the BRINE
position to the BACKWASH position. If
screen is locked, the screen will display
“PRESS SETTINGS 3S TO UNLOCK”. Fol-
low the instructions and press SETTINGS
for 3 seconds to unlock. Press and hold
the MANUL REGEN. Key for 3 seconds.
Press any key to skip the BRINE cycle.
4. Open the inlet on the bypass valve
slightly and very slowly allow water
to enter the unit. (If the water en-
ters too quickly it will push the car-
bon up into the control valve and get
plugged).
5. Once the unit has filled sufficiently
that water is at least equal to the
height of the top of the media in both
tanks, shut down the water for 15 –
20 minutes for the carbon to soak.
Unplug the power cable. After the
carbon has soaked for the recom-
mended time continue by plugging
the power cable back in.
6. Turn the water back on slowly to back-
wash until water runs clear to drain.
7. Press any button to advance to the RINSE
position. Check the drain line flow. Allow
the water to run for 3-4 minutes or until
the water is clear.
8. Press any button to advance to the REFILL
position. Check that the valve is filling wa-
ter into the brine tank. Allow the valve to
refill for the full amount of time as dis-
played on the screen to insure a proper
brine solution for the next regeneration.
9. The valve will automatically advance to the
SERVICE position. Open the outlet valve
on the bypass, then open the nearest
treated water faucet and allow the water
to run until clear, close the tap and replace
the faucet screen.
10.Add salt into the cabinet / brine tank.
11. Program unit.
Start-up Instructions
DELAYED REGENERATION
Press and release the MANUAL REGEN. But-
ton to set a delayed regeneration that will
occur at the regeneration time. The main
display will show DELAYED REGEN ON. To
cancel press and release the MANUAL RE-
GEN. Button. The main display will show DE-
LAYED REGEN OFF.
IMMEDIATE REGENERATION
To start an immediate regeneration (or step
valve through each position), press and hold
the MANUAL REGEN. Button for 3 seconds
(until beeps). The valve will start an immedi-
ate regeneration. Press any key to skip to
the next cycle.
Manual Regeneration (Step / Cycle Valve)
8
Summary of Contents for HTO-185HEUF
Page 7: ...Installation 7...
Page 20: ...Power Head Exploded View 20...