MODELS: BVC75 & BVC100
•
INSTALLATION & OPERATION INSTRUCTIONS
BVC75-INST
Rev. Jun08
TM
P/N
120HEAD34 or
120HEAD100
P/N
G10105
P/N
12010 Clear
P/N
BRN01
Not shown: Wrench (P/N BWR34)
Installation Precautions
You must read all of the written material and follow all of the precautions and directions before beginning an
installation. All existing local and state plumbing codes must be followed.
•
Operation Pressure Range: 20 to 100 psi (140 to 690 kPa)
•
Operating Temperature Range: 40° to 100° F (4° to 38° C)
•
For cold water supply line installation only
•
Do not locate unit in direct sunlight. Protect the unit from freezing.
•
Chemical solvents should not be used to clean the unit. Only warm water with mild soap may be used, rinsing
afterwards with clean water.
•
Threads should be sealed using only Teflon
®
tape.
Do not use thread sealing compounds or paste.
•
Using a torch near plastic housings can cause damage to the filter. Sweat joints must be made before attach
-
ing to the filter head.
•
If the water piping is used as an electrical ground, then a jumper wire must be installed around the filter.
•
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection
before or after the unit. Units certified for cyst reduction may be used on disinfected waters that may contain
filterable cysts.
Warning:
You must consult a water quality professional to test your water and recommend any necessary
treatment for bacteria, chemicals, or other possible contaminants not removed by this filter. This cartridge will
lose its effectiveness over time and must be changed in accordance with the printed instructions.
Blake Water Solutions
