Quick Set up Guide WG13 Alarm & Keypad 29 03 2022 V1
Carbon Monoxide Alarm
Pairing your Carbon Monoxide Alarm
Ensure the Alarm Base Station is plugged in and turned on:
STEP 1
. Open the back of the Carbon Monoxide Alarm and remove the plastic covering from
the battery. Re insert the batter taking time to ensure you have the b and – matched
correctly.
STEP 2.
From the App on your phone, on the device home screen in App tap Accessories >
+, then the base station goes into the pairing/sniffer mode with all indicators blinking.
STEP 3.
Press the “Test” button on the alarm, a light will flash and sound alert. The wireless
Carbon Monoxide alarm sensor will send a transmission signal to the base station and once
paired the base station emits a sound.
STEP 4.
Name your device, set the type and mode of your device.
Zone mode will default
to 24 hours for your CO Alarm and should NOT be changed from this.
Please see above
instructions under Name/Type/Mode of each sensor.
Bracket installation:
Using Screw fixings - Choose the installation location, first make two holes in the ceiling or
wall, then insert the wall plugs into the holes. Insert the screws into the holes of the plate,
screw tightly to fix the bracket firmly.
Fit the battery into the battery holder of the alarm, align the back of alarm and rotate clockwise
to lock in place.
Gently press the test button to confirm the alarm is working.
Using the double-sided adhesive pads - Peel the paper from one side of the double-sided
pads and stick the pads to the backet on either side of the central hole and press firmly to
ensure a good bond. Peel the paper from the other side of the adhesive pads and fit the
bracket in the selected location, pressing firmly to ensure a good bond.
