Quick Set up Guide WG13 Alarm & Keypad 29 03 2022 V1
Installation of the Door / Window Alarm Sensor
Before securing your sensor in place, please test the sensor at the location you wish to fit it,
to ensure it is within range of the base station by separating both contacts at the location you
wish to install it, with the alarm armed.
It is not advised to mount the motion alarms or entry sensor onto metal surfaces as the metal
can block RF signals between the transmitting sensor and the base station.
Please ensure the surface is flat and clean where you intend to install the sensors.
Using the double-sided adhesive pads to install the door/window sensor
Fit the Double-Sided Adhesive pad firmly to the back of both parts of the sensor.
Carefully place the sensors where required and press to ensure a secure bond
.
Note:
the maximum distance both parts can be from each other is 2.5 cm. If the gap on the
door/window to the frame is greater than 2.5cm in depth you can use PIR motion alarm instead
in this location.
With the alarm armed, open the entry door/window to test the alarm is working correctly.
Wireless PIR Motion Sensor
Pairing your Wireless PIR Motion Sensor
Ensure the Base Station is plugged in and turned on.
STEP 1
. At your device home screen in the App tap Accessories > +, then the base station
goes into the pairing/sniffer mode with all indicators blinking.
STEP 2.
Trigger the wireless PIR motion sensor that you wish to add to send a transmission
signal to the base station before its 20 second sniffer countdown expires, once paired the base
station emits a sound.
To trigger the PIR for pairing- Press the black button on the back for 5 seconds and the blue
light will flash.
STEP 3.
Name your device, set the type and mode of your device. Please see above
instructions under Name/Type/Mode of each sensor.
