Users Manual WG13 Alarm & Keypad 04 04 2022
How to Connect your Keypad to the Base Station
STEP 1.
Set your base station into pairing/sniffer mode.
STEP 2.
Enter
user passcode
then press to send arming transmission signal to base
station.
STEP 3.
The base station will beep to confirm pairing successful.
DOORBELL
If you wish to use the doorbell function on the keypad, the doorbell identification number
in the transmission code to the base station is different from the arming/disarming ID
number, so It is necessary to pair the doorbell code with your base station before using
doorbell function.
To pair the doorbell:
STEP 1.
Set your base station into pairing/sniffer mode.
STEP 2.
Press to send the doorbell transmission signal to base station.
STEP 3.
The base station will beep to confirm pairing successful.
ARMING/DISARMING Your Security System via the Keypad
Using The User Passcode.
Enter
user passcode
then press to away arm.
Enter
user passcode
then press to disarm.
Enter
user passcode
then press to home arm.
Or Using an RFID Tag.
Press then tap the RFID tag to away arm.
Press then tap the RFID tag to disarm.
Press then tap the RFID tag to home arm.
RESET
This process resets your keypad to factory settings and removes all paired RFID tags.
With the bracket attached to the back of the keypad, slide the bracket up and down 10
times which slides the
tamper switch
underneath the bracket, this will restart and reset
the keypad.
Smoke Alarm
