45
have motion event happen, then it will trigger these alarm input active. It looks like following.
For example, here we set area 1 trigger alarm input 1, area 2 trigger alarm input 2, area 3
trigger alarm input 3.
At the 5
th
line, here we can setup a simple schedule for this function, for example, here we
setup to 00:00 ~ 24:00.
After above all setup, if area 1 motion event happen, then it will trigger camera 2 go to preset
1, and trigger alarm input 1; if area 2 motion event happen, then it will trigger camera 2 go to
preset 2, and trigger alarm input 2; if area 3 motion event happen, then it will trigger camera
2 go to preset 3, and trigger alarm input 3.
Note: if many areas have motion event happen and trigger one speed dome or PTZ at the
same time, then the system will trigger all the preset one by one, and we can setup the
interval time between 2 preset. The interval option in the PTZ setup window, it named
“Preset Period”, and the value range is 1 ~ 10 sec. looks like following:
4.5.3
Video Loss
In
X310H310H310H
Figure 4-16
X
, select video loss from the type list. You can see the interface is shown as in
X311H311H31 1H
Figure 4-21
X
.This function allows you to be informed when video loss phenomenon occurred.
You can enable alarm output channel and then enable show message function.
Tips:
You can enable preset activation operation when video loss occurs.
Please refer to chapter 4.5.2 motion detection for detail information.
