CHAPTER 3: Configuration Mode Commands
62
WatchGuard Vclass 5.1
schedule command
WG#config<ENTER>
WG(config)#schedule
<”name”><enable|disable> [-all| \
-mon|-tue|-wed|-thu|-fri|-sat|-sun]
{hr:min-hr:min \
[hr:min-hr:min ][hr:min-hr:min ][hr:min-
hr:min ]}<ENTER>
Effect
Use this command to set up a schedule for use in
the application of policies. Schedules can be set up
for the same hours for every day or for different
daily schedules, depending upon the arguments.
Arguments
<"name">
Type a short, descriptive name for this schedule.
<enable|disable>
This argument specifies whether this schedule is
currently active or not.
-<day>
This argument defines the days of the week. The
values can either be noted as “all” for all seven
days, or include any combination of days of the
week–mon, tue, wed, thu, fri, sat, and sun.
{hour:minute-hour:minute}
This argument (which can be repeated for different
blocks of time) should note a range of hours, such
as “9:00-12:00” (which indicates 9:00am to Noon.)
Be sure to wrap the range in curly brackets, as
shown in the examples below. Hours must be
converted to and noted in military time–
according to the 24-hour clock.
TIP
A midnight
start
time should be entered as “0:00”.
