Second level configuration mode commands
WatchGuard Command Line Interface Guide
87
[-unnumbered_pppoe <a.b.c.d>|disable]] |
[disable] |
[switch_to_backup] |
[tracking -remove|-add <a.b.c.d>
-interval <seconds>
-timeout <seconds>
-pause_before_failback <minutes> ] ]
#num is either auto reconnect delay in seconds.
#or if dial_on_demand, the idle timeout in minutes.
#ex: inter 1 pppoe -use u1 -pas xxxxx -dial 20
#backup PPPoE connection only supports ALWAYS_ON.
Effect
Use this command to configure the network
identity of a WatchGuard appliance’s interface 1
(Public), if it is a publicly routable, fixed IP address.
Arguments
<a.b.c.d>
This argument records the IP address assigned to
this interface.
</prefix|mask>
This argument records the number of bits in the
subnet mask (for example, “/16” is equivalent to
the address 255.255.0.0), or the actual subnet mask
address.
[-mtu num]
This allows you to set the size of the Maximum
Transmission Unit (MTU). The default is 1500
bytes.
[-100_full_duplex
|
-100_half_duplex|
-10_full_duplex|-10_half_duplex | -
auto]] |
This setting allows you to specify the speed at
which the interface will operate.
[dhcp ["host_id"]] |
This allows you to obtain the IP address of
interface 1 using DHCP.
[pppoe -user "name" -password
"password"]
This allows you to set Interface 1 to PPPoE. If the
