![background image](http://html1.mh-extra.com/html/warner-electric/tcs-200/tcs-200_installation-and-operating-instructions-manual_873100012.webp)
12
Warner Electric • 800-825-9050
P-2106-WE • 819-0550
Sympton C:
Brake is not engaging .
Probable Cause
Solution
Mode switch in brake off position
Set mode selector switch to run position .
Tension adjust set at 0
Increase tension adjust .
Remote mode switch in brake off position
Set remote mode switch to run position .
Remote sensors incorrectly wired
Check wiring and rewire if necessary .
No power to control
Refer to symptom A above .
Symptom D:
Brake is not releasing .
Probable Cause
Solution
Mode . switch in brake "on" or "stop" position
Set mode selector switch to run position .
Tension adjust set at maximum
Reduce level and see if brake rotates .
Remote mode switch in brake "on" or "stop" position
Set remote mode selector to run position .
Remote sensor incorrectly wired
Check wiring and rewire if necessary .
Mechanical binding
Check brake for freewheeling when control power is off .
Correct if mechanical problems still exist .
Symptom E:
Brake does not have adequate torque capacity
.
Probable Cause
Solution
Brake is incorrectly sized
Verify brake sizing by repeating the selection procedure .
Brake is incorrectly wired
Recheck wiring and magnet connections and rewire if
necessary .
Local or remote tension adjust incorrectly set
Recheck set-up procedures for the mode of operation the
control is used in . Readjust if necessary .