©2015 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
10 96551A2
Figure 2
The following steps are for the installation
of your new WARN bumper for the 1500,
2500/3500:
1. Remove the trailer harness receptacle (unless previously
removed), by squeezing the two tabs together and push
outward.
2. Unplug license plate lamp by twisting bulb housing and
removing screw.
3. If vehicle is equipped with vehicle rear sensors, remove now.
NOTE: The sensor unclips from the sensor retainer, then
the retainer unclips from the bumper. See Figures 9 and
10.
NOTICE
Be careful when removing sensors and sensor
retainer from bumper as to not damage
.
4. Repeat steps for other side.
5. Carefully, remove OEM spare tire access housing.
NOTE:
Using a pick, bend each prong back and out of way. Take
care, bending prongs as to not damage because you will
be reusing in new bumper.
Trailer harness
receptacle
Tabs
License Plate
Lamp and screw
Sensor Retainer
Sensor
Sensor and Sensor
Retainers
Figure 1
Figure 3
