Waring WFP16SE, Instructions Manual

Page: 16 / 152

16
TROUBLESHOOTING
This section describes potential problems and the correct
solutions for them. Problems that cannot be solved with the
guidelines listed below should be referred to one of the Waring
Authorized Service Centers for assistance. A listing of authorized
service agencies is supplied with each Waring food processor.
Unit does not start when assembled correctly
• Pull the plug and try plugging into another outlet.
• Press ON button.
• Make sure the bowl is properly positioned on the motor base,
that the bowl cover and large pusher are attached properly,
and that the safety interlock tab on the cover has properly
engaged the safety interlock switch.
Unit stops running during processing
• The unit may have overheated. Refer to Resetting Thermal
Protection section (page 11).
• Turn unit off and unplug.
• Remove bowl attachment.
•
Remove food being processed from inside the bowl and discard.
• Allow unit to cool for 30 minutes.
• Reassemble unit, and run first with the bowl empty, then put
food into the bowl and try again.
Unit jams or vibrates excessively
• Turn unit off and unplug.
• Disassemble the batch bowl/accessories.
• Make sure there is no food in S-blade hub (if applicable).
• Clean food off accessory discs (if applicable).
• Reassemble unit, and run first with the bowl empty, then put
food into the bowl and try again.
Unit will not come up to full speed
• Bowl is overloaded – remove food being processed and reload
using smaller quantities.