Walther Systemtechnik WLVCM, Operating Manual

Page: 19 / 37

Operating Manual WLVCM-BA-10
Page 19 of 37
EN
6.2.2 Optical Interface O1
The O1 optical interface comes with a total of eight light diodes (se also figure xyz); they indicate the
system statuses of the WLVCM:
LED Name Value Specification
1 Error temperature
ON Temperature not within tolerance range
OFF Temperature within tolerance range
2 Error current limitation
ON Authorized current for clamp “Valve +“ exceeded
OFF Current at clamp “Valve +“ below limit value
3 Ready for start
ON WLVCM ready for operation
OFF WLVCM not ready for operation
4
Shot/shot sequence
active
ON Currently an application is carried out
OFF No application active
5
Shot/shot sequence
finished
ON Application finished
OFF Application not finished
6 +24V
ON Operating voltage 24VDC available
OFF No / wrong operating voltage available
7 Operating status
ON
Active date transfer between WLVCM and configuration
tool
OFF
No active data transfer between WLVCM and
configuration tool
8 Input start
ON Start signal applied (clamps „Start –„ and „Start +“)
OFF Start signal not applied
Table 9 – Light diodes of the optical interface O1 and their relevance