3 Transport
Page 12 of 37
Operating Manual WLVCM-BA-10
EN
3 Transport
3.1 Packaging
The device will be prepared by Walther Systemtechnik GmbH for a transport to the first destination.
The type of packaging depends on the individual mode of shipping. If not separately contracted, the
packaging is in accordance with the rules and regulations of Walther Systemtechnik GmbH. This rule is
in accordance with the Federal Association for Packaging HPE.
The packing unit will not be exposed to any additional strain. Packaging and contents will be protected
against any kind of humidity. The temperature for transport and storage will strictly range between –
20°C and + 40°C.
3.2 Transport
The actual transport of the device and its individual parts requires special care in order to prevent
damages from external forceful impact or careless on- and off-loading. Depending on the mode of
transportation, suitable transport and load securing has to be selected. The device will be aligned and
leveled by appropriate fastening elements.
3.3 Damages in Transport
The following will be observed when the receiving checks reveal damages in transport:
•
Contact the carrier (carrier, train etc.)
•
Write a protocol of damages
•
Contact the supplier
3.4 Location of Set-up
•
All legal requirements for the mounting site should be clarified and fulfilled.
•
Prior to installation of the equipment, the condition of the floor and the size of the surrounding
space should be checked to ensure safety of operation for both personnel and equipment. The
installation must be such that continuous operation at a high safety level is ensured.
•
The installation of the equipment as well as commissioning or storage of the equipment must be
conducted by specialists that are trained and made familiar with the equipment only.
•
The equipment is designed for use in areas which are protected from climatic conditions.
•
Operation or storage of the equipment in an aggressive or moist environment or outdoors may lead
to corrosion or other damage for which Walther Systemtechnik GmbH will not assume liability.
•
All exposed parts and lines must be mounted as such that no injuries or damage can occur
•
The minimum allowed space around the device will be closely observed.
Summary of Contents for WLVCM
Page 37: ...Article Number WLVCM BA 10...
