90
490120A
Things to note when selecting the installation location
When installing the device, bear in mind that the device must be detached for
maintenance. Therefore, it is advisable to make the connections easy to open and
disconnect.
The stove should be installed level. The inclination must not exceed 5°. While the
device might not break if it is temporarily tilted to a steep angle (even for some
hours), the burner will not yield optimal performance if it is constantly inclined.
Also consider where you will place the control panel, as the length of the control
panel’s cable may pose some limitations.
Avoid installing the control panel in the immediate vicinity of a water outlet.
If possible, install the control panel on a vertical surface.
Moreover, the stove should not be installed on top of a refrigerator. The stove will
heat its surroundings and thus decrease the power of the refrigerator.
We recommend that the device be installed by an authorised Wallas service shop.
Things to note when installing pipes, hoses and cables
Power cables and fuel hoses must be protected in locations where they are sus-
ceptible to mechanical damage due to sharp edges or heat.
GB
Installation
In a metal-hulled boat, you must ensure that the device, the fl ue gas
lead-through, the fuel connection, the control panel, and all other parts
are insulated from the boat’s hull. This must be done to:
prevent electrochemical corrosion
•
prevent voltage from being transmitted from the hull to the device
•
or vice versa during electrical faults.
Always use original Wallas accessories and parts with Wallas equip-
ment.
90.indd 4
20.01.2010 14:49:01
- 41 -
