G:\INSTRUCT\Sanismart Plus\Sanismart Plus Instructions.docx 9/9/2020 Page 2
1. DIMENSIONS, GENERAL VIEW & CONNECTIONS
Dimensions: -
General view & connections: -
Cut-away view through the cover showing the dry mounted pump motor unit & circuit board, in a separate chamber provided in
the collection tank. Also shown is 1 X toilet pan connection, 2 X inlet connections on sides of the tank at lower level typically for
connecting shower, bath and other lower level amenities, 1 X additional optional connection on top of tank right side typically for
higher level discharging amenities like hand basin, sink etc.
SANISMART PLUS DIMENSIONS
1: Pump Cover.
WARNING
– Pump Cover
is not water tight. Water
dripping on to Pump Cover
may cause pump failure
and hazard.
2: Collection Tank.
!!! Warning !!!
Do not dump condoms,
sanitary pads, wet wipes,
tampons, hair, nappies,
non-water soluble paper
towels, cardboard,
plastic bags, fat, oil,
sand, stones, tar,
cement, paint etc.
This may cause pump
failure, flooding & hazard.
3: Pan Connection
4: Pump
Discharge
9: PVC Swing
Check Valve
6: Shower / Bath
Connections on
Either side of tank
5: Tank Vent
Connection
7: Additional Optional
Inlet Connection fat top
for WHB / Sink
8: Manual Run /
Reset Button
10: PVC Isolating
Ball Valve
