Page 26
11.
DO disconnect the mains supply or isolate the supply before:
a.
Emptying fluid from the tank
b.
Filling the tank with fluid
c.
Moving the unit
d.
Removing the base screws*
*NO USER SERVICEABLE PARTS ARE CONTAINED IN THE UNIT
12.
DO keep the front panel dry. NEVER allow fluid to run down the unit case
or around the cable inlet/outlet areas.
13.
DO NOT operate ANY switches when your hands are wet.
14.
DO keep the special waterproof RS232 and USB connector covers on
when not in use.
15.
DO use the correct accessories with the unit. DO NOT use any glass or
other containers in place of the recognised beaker.
16.
The unit should be operated in an environment as follows:
Temp: 5°C to 40°C - Humidity: 10% to 80% (Non-condensing)
17.
After long periods of operation, the top of the tank and fluid may get
quite warm. This is quite normal.
18.
In the event of failure/emergency, disconnect the mains supply by
removing the plug from the mains socket.
19.
It is advised that in the interests of staff comfort the user should move at
least one metre away from the unit once it is operating.
20.
DO NOT Flash test this equipment.
21.
Refer to Walker Electronics publication “Ultrasonic cleaner periodic
testing advice” for HTM01-05 advice. This information is also available in
the Downloads -> Advice Sheets section of our website
www.walkerelctronics.co.uk
IF THE EQUIPMENT IS NOT USED AS SPECIFIED IN THIS HANDBOOK THE
PROTECTION PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED
