Page 12
The user number can be adjusted by pressing the and keys. If you
are a new user write your name against your user number on page 31 of
this handbook. Should you wish to cancel the cycle press the key.
When the correct user number is displayed press the key (start/stop).
The cycle will then start.
The unit will ‘click’ several times before starting. This is to enable the unit to
start at the next whole second as well as checking that the fluid level is
correct.
If this is the first cycle since the unit was connected to the mains and the
degas cycle time is set above 0 seconds (see page 7), the word ‘Degassing’
will be displayed in the bottom left hand corner of the screen. After the
degassing cycle has completed the unit will start the full cycle.
When the full cycle starts a screen similar to the one below is displayed:
In this example:
150W This means that the unit is drawing 150 Watts. This figure will vary
depending on many things such as the power setting, fluid
temperature, the fluid level, the mains voltage, the basket loading
and even the type of fluid used. This figure however should be in the
range of 140 - 250 watts if the power level is set to 100%. A figure
below 140 watts indicates there may be a problem with the unit.
The fluid in the tank is too hot so this screen will be displayed:
Either replace the fluid or wait for the fluid to cool down.
…
