245.805.011
27
Date: 2021-12-09
Adjusting procedure
1.
Put the Winch 50 Series in manual mode while adjusting the limits.
2.
Localise the hard limit switch box, the black box just in front of the fan.
3.
Loosen the two screws holding the lid.
4.
Loosen the middle screw.
5.
Hard BOTTOM limit is adjusted by turning the screw with a 1 next to it.
6.
The hard TOP limit is adjusted by turning the screw with a 2 next to it.
7.
When adjustments are done tighten the middle screw again.
8.
Mount the lid with the two screws again.
The hard limits are factory pre-set to stop 3 cm below the winch and have a travel length
of 12.5 m. It is not advisable to adjust the hard TOP limit closer to the winch than 3 cm.
Note that for software versions before 503.001.012 the stopping distance was longer
hence hard top limit should not be closer to the winch than 10 cm.
Summary of Contents for 50 Series
